How do I make 5cpserver switch controller ports?
#1
Hard to explain but I want 5cpserver to consider my 1st controller as if it was a 2nd controller. Sort of like the thing you have had to do in metal gear solid where the game asked you to switch the controller ports from 1 to 2.
Reply

Sponsored links

#2
Does it have anything to do with this?

http://puu.sh/aNMaR/84bd396cd6.png
Reply
#3
Experimented a bit, here are my results:
Plugged 2 micro-usb cable into the computer, connected the first to the DS4 and it counted as PAD1, after reattaching the DS4 to the 2nd cable the computer have counted the controller as PAD2 for about 4 seconds and then came back to the first one. PAD2 now says "reserved".

Maybe if I have 2 micro-usb cables I could make it think I have 2 pads?
Reply
#4
You have already two and it didn't work, r?
Reply
#5
(08-12-2014, 10:58 PM)willkuer Wrote: You have already two and it didn't work, r?
I have two cables and it didn't work, that is indeed correct. If nothing works I will just buy a 2nd controller that I will never use but I would rather avoid that if I can. Unless I suddenly get additional sibilings =w=
Reply
#6
Is it pcsx2 related? You can also switch controller in lilypad settings...
Reply
#7
Open ScpMonitor.exe and use the little arrows to switch the controllers around.
Reply
#8
(08-13-2014, 05:53 PM)willkuer Wrote: Is it pcsx2 related? You can also switch controller in lilypad settings...
I can? How do I do that?

(08-14-2014, 08:23 AM)shockdude Wrote: Open ScpMonitor.exe and use the little arrows to switch the controllers around.
http://puu.sh/aRTwC/6e1b1bbf54.png

The buttons do not appear to be clickable
Reply
#9
Played around with ScpMonitor and the buttons are still greyed out, what did shockdude mean?

What am I supposed to do with lilypad?
Reply
#10
ScpMonitor still isn't being helpful ;-;

Lilypad is a lot of text, what do I edit?
Reply




Users browsing this thread: 1 Guest(s)