No proper Code Support
#11
http://i126.photobucket.com/albums/p88/Blob55/Dupt.png

The P1 Code doesn't show up at all.
Reply

Sponsored links

#12
I don't think you need that at all.
[Insert Witty Sig Here.]
Reply
#13
Either way, I can't use this time code for Katamari Damacy. 201022C0 24420001 It's supposed to be RAW/Unencrypted, converted from GameShark V3.
Reply
#14
(06-04-2014, 05:15 AM)Blob55 Wrote: Either way, I can't use this time code for Katamari Damacy. 201022C0 24420001 It's supposed to be RAW/Unencrypted, converted from GameShark V3.

What does the console says?
[Insert Witty Sig Here.]
Reply
#15
@OP: Code support shall be sought with the cheat engine developers, like Code Breaker, ARMAX and such, there is where you may ask why they encrypt their codes, since what actually goes into PS2 or PCSX2 (in the case) is the raw code (which the engine automatically convert where used).

Now, to try and let things a bit clearer, the input must be always the same as the engine manufacturer, besides it must be for the same version the code was done. For example Code Breaker has the version 1 to 6 which uses the same encrypting and then v7+ which uses another one.

The output must be standard raw, always. That's because RAW is the "actual" address offset and actual value to be put in that address instead some masked values (gibberish).

One final hint: Always convert from the original code, don't try converting from an already failed previous conversion, that would return meaningless results.
Imagination is where we are truly real
Reply
#16
I did convert from the original Gameshark V.3 code, but it doesn't work.
Reply
#17
Can you paste the website's URL or the text of the original codes?
Reply
#18
http://bsfree.shadowflareindustries.com/...=8&g=10231

Apparently these were from the original Gameshark website.
Reply
#19
(06-04-2014, 12:28 PM)Blob55 Wrote: http://bsfree.shadowflareindustries.com/...=8&g=10231

Apparently these were from the original Gameshark website.

As far as the codes, Omniconvert settings would be below.

Input -> GameShark -> MadCatz -> Version 3 - 4 or Version 5+ (Both available)
Output -> Unencrypted -> Standard

Also, "[M] Must Be On" (or Master Code, Enable Code) is no need for emulators.


BTW, these codes seem to be one time code. ("Only Use One Time Code At Any Time")

Try my tool PCSX2OTC instead of pnach method from the link of my signature.
Reply
#20
So will it work after I've used it?
Reply




Users browsing this thread: 2 Guest(s)