Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sly series run on constant 60FPS until
#1
Lasers... They seem to be the major fps killer on Direct 3D 11/9 but switching to opengl will slightly help but only a 2 fps difference from the 40 fps it drops down too
Does anyone know the cause or any possible fixes?


Specs
I7 3770 4.5ghz
GTX 1050 2G
14GB 1600mhz ram


What is enabled along with default
MTVU = yes
enable fast cd access = yes


Graphics plugins:
Direct 3D 11
Internal resolution = 3x native
Anistrophic filtering = 8
mip mapping = basic
crc hack level = full
Reply

Sponsored links

#2
What version of PCSX2 are you running?
[Image: ref_sig_anim.gif]
Like our Facebook Page and visit our Facebook Group!
Reply
#3
In the past when I was on a low end laptop setting skip draw to 1 to remove a level of post processing would help performance, but your specs seem decent enough to not need that. I suppose you can try it though and see what happens.
i7 5775C @3.3 Ghz
RX 480 8Gb
32Gb DDR3 RAM @2133 mhz
Reply




Users browsing this thread: 1 Guest(s)