Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Some kind of bug?
#1
Specs:
C2D P8600 @ 2.4 GHz
Ram 3gb
9600m gt 512mb
PCSX2 v 0.9.7

So the problem is, when I change the renderer it just doesn't save just stay at Hardware mode DX9 o.O If i put software when i start the game is HW DX9 again. I tryed with DX10 SW, HW, with DX9, DX10 null and continues to display image. Doesn't matter what I change it just stays the same.

Any thoughts?
Reply

Sponsored links

#2
update Direct X?
Reply
#3
(12-22-2010, 10:22 PM)Saiki Wrote: update Direct X?

It is updated :/
Reply
#4
try it again to make sure
Reply
#5
(12-22-2010, 11:18 PM)Saiki Wrote: try it again to make sure
already did like 3 times
Reply
#6
ok then, well, I believe that the DX9 and DX 10 modes are both hardware. you can hit F9 to go to software mode for one.

the second part you need to realize is that you can't change these settings ingame (the hacks, yes, not the display settings)
Reply
#7
(12-22-2010, 11:20 PM)Systematic Wrote: already did like 3 times

Yea, I know that. I change them before open any game and they still return to dx9 hw, it's wierd o.O
Reply
#8
run pcsx2 as administrator
Reply
#9
(12-23-2010, 12:41 AM)Saiki Wrote: run pcsx2 as administrator

I already did
Reply
#10
Your GSdx.ini isn't getting saved.
- Try to move your entire PCSX2 installation folder to C:\ and run it from there.
- Try config > clear all settings and choose another working folder for PCSX2.
Reply




Users browsing this thread: 1 Guest(s)