(11-13-2014, 09:17 AM)Asyra Wrote: [ -> ]Second issue is that I can't get the DS3s to work with bluetooth at all. I'm not sure if I missed some step in the installation or what the hell is going on. After the installation I simple unplugged the DS4s and pressed the PS button, and they were paired. No such luck with the DS3s. If it isn't possible to have both side by side, I'd be fine with the DS3s being wired.
Anyway, if anyone has some experience connecting both DS3's and DS4's via bluetooth, I'd love to hear from you. Oh, and if there's anything I can tell you about my setup that would be helpful in figuring this out, go ahead and ask. Thanks.
I am having the same issue with my Dualshock 3. The controller works perfectly when wired. But when I unplug it and press the PS button, nothing happens at all. There doesn't seem to be anything wrong with the controller itself, as it is brand new, it is fully charged, and I do not have a PS3 so I cannot test it on that.
Like Asyra, I expected to unplug the DS3 and press the PS button and that would pair it with my Bluetooth dongle. But that is not happening. My dongle is in the supported list.
I installed the drivers using ScpDriver, and they seem to have installed successfully. When I plug the dongle in, it shows up in the Device Manager as "BTH DS3 Device". When I plug the controller in, it shows up in the Device Manager as "USB DS3 Device", and the controller works just fine on my emulators when it's plugged in. But when I unplug the controller, I cannot connect it to my Bluetooth dongle! Pressing the PS button does nothing.
Looking through the thread, I have the EXACT SAME DONGLE and the same problem that is mentioned below (SB\VID_0A12&PID_0001&REV_0134). So I tried using Zadig to update the driver, but this did not fix the problem. The dongle shows up perfectly in Device Manager, but my controller will not connect to the dongle! What am I missing?
If anyone has any help on this issue, I would appreciate it so much. Thank you.
Edit: another point I just noticed: my dongle shows up in the device manager, but it DOES NOT SHOW UP IN SCPMONITOR!!!!!!!!! I've tried a regular install, AND I've tried a Force Install, AND I've tried using Zadig. None of these things have gotten the dongle to show up in SCPMonitor. But it always shows up in Device Manager as BTH DS3 Device.
And, again, my controller works just fine wired! For that, I am grateful for this software, because I can finally play GC and PS2 games. But I am still having trouble getting my DS3 to work wirelessly.
Bigby Wrote:I have been using the XInput Wrapper for some time, and have had no issues connecting a DS3 controller via USB or Bluetooth. I wanted to use a DS3 on another PC, so I bought the same Bluetooth USB Dongle that I had been using. However the new dongle does not allow me to connect a DS3 (I can of course connect using a USB cable). I thought that the dongle may be faulty, so I bought the same one again. No luck, this also does not pair a DS3. I tried the dongle's on both PC's as well just to make sure it was not the other PC.
I compared all three dongles, and the difference I see is in their rev number:
Old and working dongle - USB\VID_0A12&PID_0001&REV_3134
The two non working dongle's - USB\VID_0A12&PID_0001&REV_0134
I tried replacing the driver using zadig, but this did not fix the problem.