01-30-2013, 02:53 AM
Hiya!
I can't get PCSX2 to get past the First Time Configuration screen. In the initial configuration page, I set up GS based on the specs of my graphics card and configured my controller etc, hit Next, and it tells me I need to update some DirectX libraries, so I did (even though I already had DX11 installed), but each time I run PCSX2, it still says I need to update. Anyways, click through that, and it tells me the selected GS plugin failed to load, hardware/drivers not supported message. Using the most current driver
(Dec 29th 2012), and specs of the machine are more than adequate I think. What am I doing wrong?
Clean install of v1.0.0 r5350
GeForce 8400 GS 1024MB DDR3 card
12G DDR2 RAM
Core i7 920 @2.67ghz (8 CPUs)
I can post screenshots or DxDiag output if it'll help. Hoping I'm just overlooking something.
Thank you for your time!
Rahve
I can't get PCSX2 to get past the First Time Configuration screen. In the initial configuration page, I set up GS based on the specs of my graphics card and configured my controller etc, hit Next, and it tells me I need to update some DirectX libraries, so I did (even though I already had DX11 installed), but each time I run PCSX2, it still says I need to update. Anyways, click through that, and it tells me the selected GS plugin failed to load, hardware/drivers not supported message. Using the most current driver
(Dec 29th 2012), and specs of the machine are more than adequate I think. What am I doing wrong?
Clean install of v1.0.0 r5350
GeForce 8400 GS 1024MB DDR3 card
12G DDR2 RAM
Core i7 920 @2.67ghz (8 CPUs)
I can post screenshots or DxDiag output if it'll help. Hoping I'm just overlooking something.
Thank you for your time!
Rahve