10-08-2018, 07:27 PM
(This post was last modified: 10-22-2018, 07:42 PM by lightningterror.)
Hi all,
First post.
So been having an issue with my PS4 controller on Revisions e44fc33 & f965502 1.50, think I found out what it is. In the latest stable release 1.4. if I unplug a controller (sometimes have 2 plugged in) it defaults to pad 2 been disconnected but in the above revisions it defaults to Pad 1 so can't get the pad to work unless I have them both attached at the same time which isn't always possible. If I unplug it whilst the software is open its fine but if I don't have both plugged in or disconnect one before opening it, it reverts to Pad 1
Apologies if this isn't the correct area to post this, I wasn't sure.
First post.
So been having an issue with my PS4 controller on Revisions e44fc33 & f965502 1.50, think I found out what it is. In the latest stable release 1.4. if I unplug a controller (sometimes have 2 plugged in) it defaults to pad 2 been disconnected but in the above revisions it defaults to Pad 1 so can't get the pad to work unless I have them both attached at the same time which isn't always possible. If I unplug it whilst the software is open its fine but if I don't have both plugged in or disconnect one before opening it, it reverts to Pad 1
Apologies if this isn't the correct area to post this, I wasn't sure.