OK, so I just played Sly 1 through all the way at 1080p, d3d11 hardware, and otherwise default settings with no slow downs. Here I am trying to play sly 2, using the safe room in the first world as a benchmark, and I can't get the FPS to go over 46. It won't go much below that, either. I've tried changing the resolution all the way from 256x256 to 8x native resolution and the framerate was actually about 4 frames better at 8x native?? Is this normal? I've never seen a game care so little about what resolution I set it to. I tried setting sly 1 to 256x256 out of curiosity and my framerate uncapped went from 75 to 120.
I've tried messing with speedhacks too and the only way I can get it at 60 is cranking them all until it's unplayable. Sly 3 runs only slightly better. I would just write it off as the games being intensive, but there are people on the pcsx2 wiki that claim sly 2 ran fine with specs nowhere near as good as mine. I feel like there's some specific setting or fix I'm missing, or something I messed up. As far as I'm aware I haven't forgotten about any settings that I changed.
Specs:
NVIDIA GeForce GTX 1050 Ti 4gb
Intel i7-3770 @ 3.4ghz quad core
8gb ddr3 ram
PCSX2 1.6.0
I've tried messing with speedhacks too and the only way I can get it at 60 is cranking them all until it's unplayable. Sly 3 runs only slightly better. I would just write it off as the games being intensive, but there are people on the pcsx2 wiki that claim sly 2 ran fine with specs nowhere near as good as mine. I feel like there's some specific setting or fix I'm missing, or something I messed up. As far as I'm aware I haven't forgotten about any settings that I changed.
Specs:
NVIDIA GeForce GTX 1050 Ti 4gb
Intel i7-3770 @ 3.4ghz quad core
8gb ddr3 ram
PCSX2 1.6.0