Well I really wanna play DBZ Budokai Tenkaichi 3 with good graphics and at a good speed (possibly 70fps 'coz I feel 60 is slow for the game).
Here are my specs :
C2D e7500 2.93ghz
9600GT 1 GB (ddr2 one)
2GB ddr3 ram
Any suggestions for settings and which build to use?
latest beta, tru VUskip level 1, and eex1.5 also note: 60FPS is native speed for the PS2, so that's how fast it would be on a real PS2.
Tried with gsdx 1.4 & 1.5.
Same results getting 40~50 fps
i found out that actually speedhacks in this game just fake fps reading without giving any real fps improvement,so dont use any speedhacks.
Does having DX10 really impact the game's performance and quality?
it does.
quality : yes (some glitches actually don't occur with dx10)
performance : not much, but quite a bit.
I got the game working at full FPS with a wierd config
But it only works at full fps when in fullscreen mode. I wanted to know why is that??
I used :
r3058 and r1888
GSDX 0.1.4 [FRAMESKIP MOD]
ZeroSPU2 r2469
Speed hacks :
EE Cycle rate : 3
VU Stealing : 0
INTC spin detection
IOP x2 cycle rate hack
Framlimit 60FPS
To draw 2
To skip 1
CPU Options
EE rec :
Rounding : Chop/Zero
Clamp : None
Vector Unit :
Rounding : Nearest
Clamping : Normal
(05-26-2010, 04:09 PM)IcyElf Wrote: [ -> ]Vector Unit :
Rounding : Nearest
Clamping : Normal
how did those gave better speed than putting them to chop zero and none?!
Dunno but they did I can even play at 70fps at moments
you will get lower if you put them where i said?