Up to now, I could use 0.9.6, it loaded my iso correctly.
Actually, I used daemon tools to load the iso into a virtual drive, and then played from this drive.
Now, with 0.9.7, I cannot load any iso, and I couldn't find an option to start from a drive.
I'm using Windows 7 64 bits.
What should I do?
don't mount it in daemon tools
just use the iso selector and make a fast boot
(09-08-2010, 07:02 AM)jesalvein Wrote: [ -> ]don't mount it in daemon tools
just use the iso selector and make a fast boot
I tried to load directly the iso using the iso selector, but when I try to run, it says the CDVD can't initialize.
Why do you mean by "make a fast boot"?
(09-08-2010, 10:40 AM)Laksha Wrote: [ -> ]I tried to load directly the iso using the iso selector, but when I try to run, it says the CDVD can't initialize.
It's probably still mounted in daemon tools.
Quote:Why do you mean by "make a fast boot"?
"System > Boot CDVD (fast)"
Oh, you mean that if it is mounted in daemon tools, it will create a conflict?
I'm not sure I tried without it mounted.
I'll check.
Yes it will, it must not be loaded in any other external application or there will be a race condition resulting in PCSX2 failing to load your ISO.
I checked, and it now works.
I was so used to load the iso in daemon tools with 0.9.6 that I always did that without even noticing it
