..:: PCSX2 Forums ::..

Full Version: PCSX 0.9.8 controller setting?
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Greetings,
I just installed PCSX 0.9.8, with BIOS, and other configuration and it seems to work perfectly. However not for the controller setting. The configuration of my controller is shown as screenshot below:

General
[Image: generalbl.jpg]

Pad 1
[Image: pad1i.jpg]


It seems that the "Pad 1" tab does not have any device, so it doesn't recognise. Are there any ideas regarding this matter?

Thank you in advance
As your 1st screenshot shows it, a dualshock controller is recognized in pad 1.
As your 2nd screenshot shows it, you didn't configure any binding.
That is your next step Tongue2
(02-03-2012, 08:24 AM)jesalvein Wrote: [ -> ]As your 1st screenshot shows it, a dualshock controller is recognized in pad 1.
As your 2nd screenshot shows it, you didn't configure any binding.
That is your next step Tongue2

ahh Wacko
I am just too dumb that I didnt realise u could actually click each command button and hit the key. Thank you very much Biggrin
I thought all the buttons would give you a hint that you have to click on them Tongue