..:: PCSX2 Forums ::..

Full Version: D-pad not working properly
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
I have a problem with my D-Pad using PCSX2. I use my DS3 controller but I have to press the D-pad buttons very hard before it registers it, and most of the time it sees it like I'm holding the button (which is kinda true since tapping doesn't work).


Please help.
I had that problem in a version. I think how I fixed was to delete all the profiles what it sees for controllers and started from scratch. Try that.
(12-26-2013, 05:41 PM)fade2black001 Wrote: [ -> ]I had that problem in a version. I think how I fixed was to delete all the profiles what it sees for controllers and started from scratch. Try that.

how?
Go to the ini folder and delete lilypad.ini
That seemed to work.... Too bad I can't fix the game (Soul Calibur 3).
Whats wrong with SC3?

I've played it lots with no problems.
Can you be more clear what happens with your sc3!
(12-28-2013, 10:38 PM)Blyss Sarania Wrote: [ -> ]Whats wrong with SC3?

I've played it lots with no problems.

Too low FPS, and using speedhacks results the ghosting effect.
What are your hardware specs?
Are you talking about this effect:

[Image: nohack_zps47f1a224.png]

?

Because if you are:

Config -> Video -> Plugin settings. Enable HW Hacks. Click configure. Set TC Offset X and Y to 500. Then it looks like:
[Image: hack_zps6d8972b0.png]

I played it bunches with EE cycle rate hack at 1.
Pages: 1 2