Sorry if this is a known issue, I've searched for quite a while and found no solutions that work for me.
I'm trying to run Shin Megami Tensei Nocturne / Lucifer's Call (PAL). The problem is that some characters and objects appear on top of things that they should be behind. It appears fine in software mode, but is too slow to play. The game runs perfectly so far in hardware mode other than the Z depth problem.
Screenshot of the problem is attached.
My specs are in my signature, here are my PCSX2 settings:
PCSX2 rev 1621
CPU Config:
EERec on
VU Recompilers on
MTGS on
Frame Limiting set to Limit
Speed Hacks:
x1.5 Cycle Rate
INTC Sync Hack on
IOP x2 Cycle Rate on
Idle Loop Fast-Forward on
Advanced:
Round Modes - Chop/Zero
Clamp Modes - None
Flush to Zero both on
Denormals are Zero both on
GSDX 1600 SSE2:
Direct3D10 (Hardware)
1536x1536
Texture Filtering on
Allow 8-bit textures on
- I have also tried Direct3D9 (Hardware) with Logarithmic Z both on and off.
- I've tried PCSX2 1474
- I've tried both PAL and NTSC modes (both are available on my copy)
- I've tried changing the Advanced settings around
Thanks for any help.
I'm trying to run Shin Megami Tensei Nocturne / Lucifer's Call (PAL). The problem is that some characters and objects appear on top of things that they should be behind. It appears fine in software mode, but is too slow to play. The game runs perfectly so far in hardware mode other than the Z depth problem.
Screenshot of the problem is attached.
My specs are in my signature, here are my PCSX2 settings:
PCSX2 rev 1621
CPU Config:
EERec on
VU Recompilers on
MTGS on
Frame Limiting set to Limit
Speed Hacks:
x1.5 Cycle Rate
INTC Sync Hack on
IOP x2 Cycle Rate on
Idle Loop Fast-Forward on
Advanced:
Round Modes - Chop/Zero
Clamp Modes - None
Flush to Zero both on
Denormals are Zero both on
GSDX 1600 SSE2:
Direct3D10 (Hardware)
1536x1536
Texture Filtering on
Allow 8-bit textures on
- I have also tried Direct3D9 (Hardware) with Logarithmic Z both on and off.
- I've tried PCSX2 1474
- I've tried both PAL and NTSC modes (both are available on my copy)
- I've tried changing the Advanced settings around
Thanks for any help.
i7 6700k @4.5GHz | Nvidia GTX 1070 8GB | 32GB Corsair DDR4 RAM | Windows 10 64-bit