Hi all. I have a quick question about this plugin; I checked a bunch of other pages of this thread but couldn't find anyone with the exact same issue, nor any solution that has worked for me, but I apologize in advance if I simply missed it.
I have installed the wrapper per the instructions and installed the update the same way. The installer reported it was successful with the same four lines at the bottom (DS3 Device installed, etc.), and the SCP Monitor accepts commands from the controller (I am using a usb cable). However, nothing else is treating it as a controller. Here is a list of information that, from other posts I've read, may prove as some clues, hopefully:
Windows 7 64 bit
Devices and Printers page in Control Panel reports BOTH the PS3 controller, and the "Xbox 360 controller", and only the PS3 controller disappears when disconnected; the 360 icon stays.
Device Manager has the 360 drivers installed as their own thing (from screenshots of other posts, it seems to be correct).
The only sign of the PS3 controller/drivers in Device Manager is a "USB DS3 Device", listed under Universal Serial Bus Devices. This entry disappears when the controller is unplugged.
In the properties of the above DS3 device, the drivers say Scarlet.Crush Productions.
As mentioned, SCP Monitor shows the controller as having a MAC address, with charge-level reported as well, and the configuration mode picks up button inputs on the DS3.
And finally, the main symptom of the issue; when I right click on either the DS3 or 360 icon in "Devices and Printers", and then click "Game controller settings", it is just a blank list.
Also, I have never used nor even downloaded MotioninJoy, and have already tried doing multiple re-installs of SCP, uninstalling the PS3 device in Device Manager, etc. So, if anyone has any ideas on this, I would greatly appreciate it! I want to play Isaac so bad
haha.
Either way, thank you all in advance!