05-02-2016, 11:31 PM
(This post was last modified: 05-02-2016, 11:43 PM by rolloVSragnar.
Edit Reason: grammar
)
Hi,
I have followed instructions - installed scptoolkit & drivers - and as a result my ds3 works fine via usb. Can't get it to work with BT however. My BT adpater is an internal atheros ar5bwb222 (USB\VID_04CA&PID_3006&REV_0001) which is supported, right? My ds3 serial number is CECHZC2Ea1, which should be genuine Sony controller.
In scpmonitor it shows my host address, so i presume it means that bt driver was installed correctly. But when I unplug usb cable pad one status changes to ''disconnected'', all 4 led lights flash multiple times and then turn off and status remains ''disconnected''.
I thought that maybe my ds3 wasn't paired with my bt adapter, so I tried doing pinhole reset several times while gamepad was connected via usb and on 3rd or 4th try notification pops up saying something to the effect 'dualshock device X was paired to bluetooth host Z'. However, after I unplug usb cable the result is the same - disconnected.
So are there any steps I could take in order to try make it work via bluetooth? Or am I out of luck?
Thanks
I have followed instructions - installed scptoolkit & drivers - and as a result my ds3 works fine via usb. Can't get it to work with BT however. My BT adpater is an internal atheros ar5bwb222 (USB\VID_04CA&PID_3006&REV_0001) which is supported, right? My ds3 serial number is CECHZC2Ea1, which should be genuine Sony controller.
In scpmonitor it shows my host address, so i presume it means that bt driver was installed correctly. But when I unplug usb cable pad one status changes to ''disconnected'', all 4 led lights flash multiple times and then turn off and status remains ''disconnected''.
I thought that maybe my ds3 wasn't paired with my bt adapter, so I tried doing pinhole reset several times while gamepad was connected via usb and on 3rd or 4th try notification pops up saying something to the effect 'dualshock device X was paired to bluetooth host Z'. However, after I unplug usb cable the result is the same - disconnected.
So are there any steps I could take in order to try make it work via bluetooth? Or am I out of luck?
Thanks